It was frustrating that the bad drive was not being reported.Īfter the system had successfully installed, I clicked Go to NAS Management on the "Congratulations" screen. It will open up the dialog box to establish the connection but it never finishes. Also the Qfinder Pro can't seem to establish a Thunderbolt connection. I can find it okay when I go to 'GO' > 'CONNECT TO SERVER' and it connects just fine. I then replaced the 4TB HDD with a 2TB Seagate FireCuda drive, and I was able to successfully install and configure the device. However the Qfinder PRO on my Mac (catalina) cannot find the NAS. As the device does not have a video port, I couldn't see any error messages, and there wasn't a way to see the error logs. Each time it did this, it took about five minutes to reboot. ![]() I tried various configurations, but it kept bringing me back to the initial configuration screen after it said that everything was installed. I cannot access a shared folder on my Synology NAS via SMB. Once my system had rebooted, I found myself stuck in an installation loop when it brought me back to the initial configuration screen and walked me through the configuration process again. You can find the MAC address in Qfinder Pro or the MAC address sticker. It formatted the drive and initialized the system, a process which took about five minutes to complete (it had a countdown timer while the process was taking place) and involved a reboot. The problem comes when I connect both devices directly using the 10Gbps connection using an RJ45 cable. I can connect to the internet in both devices. ![]() Qfinder Pro has no issues finding the qnap. I was asked to give the device a name and password, set the time, and select which file services to enable. I have my qnap (tvs-672xt) and PC connected to my switch (using the 1Gbps connections). 2 Be Sure if Qnap and your Laptop / Pc is on the same Subnet. It took less than a minute to download the firmware, and then about five minutes to install it and reboot the system. II Qnapfinder can find my Qnap but when I double click on NAS, it says Page Couldnt Found First, we must be sure if you configure and check basic setting 1 Plug Qnap directly to your Laptop / Pc.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |